Huawei FreeBuds Pro 5 White

Huawei FreeBuds Pro 5 White

Within the premium True Wireless earbud segment, the Huawei FreeBuds Pro 5 mark a notable step forward. They incorporate a Hi-Res dual-driver acoustic structure, ANC 3.0 intelligent noise cancelling and sophisticated connectivity through Bluetooth 6.0 alongside NearLink (StarFlash) technology.

High-fidelity audio reproduction is delivered by this model thanks to support for LDAC and L2HC 4.0 codecs, together with IP57 rating for protection against dust and short-term water immersion.

Dual-motor acoustic architecture

The Hi-Res Dual-Driver audio setup is made up of an 11 mm dynamic driver featuring four magnets for low bass frequencies (starting at 10 Hz), plus a micro-planar tweeter that can reproduce high frequencies reaching 48 kHz.

Active digital frequency division is managed by a dual DAC, which lets every frequency band be handled separately to boost clarity and prevent overlap between bass and treble.

Lossless wireless transmission

High-resolution codecs including LDAC and L2HC 4.0 are supported by the FreeBuds Pro 5. In the global version, a transmission rate of up to 2.3 Mbps is achieved.

When paired with NearLink-compatible Huawei devices running Kirin A3 or higher processors, a transmission rate of up to 4.6 Mbps can be reached, enhancing wireless audio fidelity.

ANC 3.0 noise cancellation with AI

The Dual-Engine ANC system powers active noise cancellation, backed by the MIMO AI Sensing algorithm. Noise-cancelling computational power is improved by up to 220% compared with earlier generations thanks to this technology.

Three high-sensitivity microphones are used by the system, along with a bone conduction sensor (VPU) that picks up voice vibrations to enhance call quality and cut wind noise at speeds of up to 10 m/s.

Various operating modes are included:

• Ultra: maximum noise cancellation.
• General: balance between isolation and comfort.
• Cozy: Soft reduction for quiet environments.
• Attention and Voice Mode: allows you to listen to your surroundings without removing the headphones.

Bluetooth 6.0 and NearLink technology

Bluetooth 6.0 provides the basis for connectivity, tuned to boost signal stability and lower power consumption.

Two devices (Android, iOS or Windows) can be connected simultaneously by the headphones, simplifying switching between smartphone, computer or tablet.

In scenarios such as gaming or Hi-Fi playback, NearLink (StarFlash) technology cuts latency and raises the bit rate.

Pinch and swipe gestures on the stem handle control, with sensitivity calibrated to prevent accidental activation.

Compact design and IP57 resistance

Compared with the previous generation, the headphones are roughly 6% lighter and 10% more compact. A matte metallic coating is used in the Silver Frost finish to minimise the appearance of fingerprints.

An IP57 certification is held, permitting dust resistance and temporary submersion in fresh water up to 1 metre for 30 minutes. IP54 certification is maintained by the charging case.

Battery life and charging

A 60 mAh battery is integrated into each earpiece, while a 537 mAh battery is incorporated in the case.

Battery life is up to:

• Up to 9 hours of continuous use without ANC.
• Up to 6 hours with ANC on.
• Up to 38 hours total with the case (ANC off).
• Up to 25 hours total with ANC on.

Fast charging via USB-C is supported by the case, delivering approximately 2 hours of playback from only 10 minutes of charging, plus Qi wireless charging support.

Technical Specifications

• Type: True Wireless Headphones (TWS)
• Connectivity: Bluetooth 6.0 / NearLink (StarFlash)
• Drivers: Dual Drivers: 11 mm Dynamic (4 magnets) + Microplanar Tweeter
• Frequency Range: 14 Hz - 48,000 Hz
• Supported Codecs: L2HC 4.0, LDAC, AAC, SBC
• Transmission rate: 2.3 Mbps (global) / 4.6 Mbps (NearLink)
• Noise cancellation: Intelligent ANC 3.0, transparency mode and voice mode
• Sensors: VPU (bone conduction), accelerometer, gyroscope, infrared, Hall, touch
• Microphones: 3 silicon microphones +