Huawei FreeBuds Pro 5 Dark Gray

Huawei FreeBuds Pro 5 Grey

The Huawei FreeBuds Pro 5 mark a notable step forward within the premium True Wireless earbud category. They incorporate a Hi-Res dual-driver acoustic design, ANC 3.0 smart noise cancelling and sophisticated connectivity through Bluetooth 6.0 alongside NearLink (StarFlash) technology.

This model delivers high-fidelity audio reproduction with LDAC and L2HC 4.0 codec compatibility, as well as IP57 rating for protection against dust and brief water immersion.

Dual-driver acoustic design

The Hi-Res Dual-Driver audio system comprises an 11 mm dynamic driver featuring four magnets for low bass frequencies (starting at 10 Hz) together with a micro-planar tweeter able to reproduce high frequencies reaching 48 kHz.

Active digital frequency division is managed by a dual DAC, which lets each frequency band be handled separately to enhance clarity and prevent overlap between bass and treble.

Lossless wireless transmission

The FreeBuds Pro 5 are compatible with high-resolution codecs including LDAC and L2HC 4.0. In the global version they reach a transmission rate of up to 2.3 Mbps.

When paired with NearLink-compatible Huawei devices running Kirin A3 processors or above, they can reach a transmission rate of up to 4.6 Mbps, enhancing wireless audio fidelity.

ANC 3.0 noise cancellation with AI

Active noise cancellation relies on the Dual-Engine ANC system, backed by the MIMO AI Sensing algorithm. This technology boosts noise-cancelling computational power by up to 220% compared with earlier generations.

The system incorporates three high-sensitivity microphones and a bone conduction sensor (VPU) that picks up voice vibrations to enhance call quality and cut wind noise at speeds of up to 10 m/s.

It offers several operating modes:

• Ultra: maximum noise cancellation.
• General: balance between isolation and comfort.
• Cozy: soft reduction for quiet environments.
• Attention and Voice Mode: lets you hear your surroundings without taking the headphones off.

Bluetooth 6.0 and NearLink technology

Connectivity is built on Bluetooth 6.0, refined to boost signal stability and lower power consumption.

The headphones permit simultaneous pairing with two devices (Android, iOS or Windows), making it simple to switch between smartphone, computer or tablet.

NearLink (StarFlash) technology cuts latency and raises bit rate in situations such as gaming or Hi-Fi playback.

Control is handled through pinch and swipe gestures on the stem, with sensitivity tuned to prevent accidental activation.

Compact design and IP57 resistance

The headphones are roughly 6% lighter and 10% more compact than the previous generation. The Silver Frost finish employs a matte metallic coating to lessen the appearance of fingerprints.

They carry IP57 certification, allowing for dust resistance and temporary submersion in fresh water up to 1 metre for 30 minutes. The charging case retains IP54 certification.

Battery life and charging

Each earpiece houses a 60 mAh battery, while the case contains a 537 mAh battery.

Battery life is up to:

• Up to 9 hours of continuous use without ANC.
• Up to 6 hours with ANC on.
• Up to 38 hours total with the case (ANC off).
• Up to 25 hours total with ANC on.

The case supports fast charging via USB-C, providing approximately 2 hours of playback from only 10 minutes of charging, plus Qi wireless charging support.

Technical Specifications

• Type: True Wireless Headphones (TWS)
• Connectivity: Bluetooth 6.0 / NearLink (StarFlash)
• Drivers: Dual Drivers: 11 mm Dynamic (4 magnets) + Microplanar Tweeter
• Frequency Range: 14 Hz - 48,000 Hz
• Supported Codecs: L2HC 4.0, LDAC, AAC, SBC
• Transmission rate: 2.3 Mbps (global) / 4.6 Mbps (NearLink)
• Noise cancellation: Intelligent ANC 3.0, transparency mode and voice mode
• Sensors: VPU (bone conduction), accelerometer, gyroscope, infrared, Hall, touch
• Microphones: 3 silicon microphones +